Oatey plumbing

Who owns oatey?

John McMillan

Where is oatey located?

Cleveland

How do you remove a oatey shower strainer?

The easiest way to remove the strainer is to weave a string or small wire through two openings near the edge of the strainer and pull straight up. It is not recommended that you pry the corner up because it could damage the shower base surface.

How do you use clobber drain cleaner?

Hold bottle with one hand and unscrew cap taking care not to squeeze or tilt bottle. 5) Slowly pour a small amount of Clobber (less than 1/4 pint) DIRECTLY INTO DRAIN OPENING. Keep face and hands away from opening. 6) If no “bubbling” or backup occurs, add rest of dosage slowly and carefully.

Should I use silicone or plumbers putty for shower drain?

However, the most ideal solution to seal this area is using plumber’s putty . Using plumber’s putty works best for it creates a waterproof seal when used on wet surfaces. In case you find it challenging to reach the underside area of the tub drainage pipe, then your best option will be silicone caulking.

Does a shower drain need a trap?

Tip. Yes, shower and tub drains require a trap in the plumbing to prevent harmful sewer gases from coming into the home.

How do you dissolve hair in a shower drain?

Combining baking soda and vinegar is a natural way to dissolve hair clogs, without resorting to harsh chemicals. Pour a cup of baking soda down the clogged drain first, and then after a few minutes add a cup of vinegar.

You might be interested:  Plumbing study

Can’t get shower drain cover off?

From the open position, lift and look for a set screw. If no screw, simply turn counterclockwise to remove. If you see a small screw, turn it with a flathead or Allen wrench until just loose enough to remove stopper (not entirely). Some pop-up drain covers pull straight up and off .

How tight should a shower drain be?

Once the flange is carefully threaded into the first few threads of the drain elbow, use the Smart Dumbell to hand-tighten the flange into the drain elbow until tight . Then use your wrench to tighten, by one quarter of a turn. Do this carefully, so as not to squeeze the gasket underneath the tub out of place.