Masonry flashing

What is masonry flashing?

INTRO TO MASONRY FLASHING . Mason contractors are usually directed to install flashing with their masonry product. Flashing acts as a barrier, which redirects moisture away from building interiors and back toward the exterior of the wall.

What is thru wall flashing?

Description: Through- wall flashing is used to divert moisture, which has entered the wall , to the outside, before it can cause damage. The ends of the flashing must be dammed to prevent water that has been caught from draining back into the wall .

Where should flashing be installed in a masonry wall?

where should flashings be installed in a masonry wall > what is the function of the flashing in each of these locations? External flashings should be installed at intersections of masonry walls with roofs or decks, to prevent penetration of water.

What is the difference between step flashing and counter flashing?

Counter – flashing : Placed opposite to base flashing , or above base flashing , counter – flashing completes the two-part team. Step flashing : Step flashing is a rectangular piece of flashing bent 90 degrees in the center. It is used for roof to wall flashing .

What is wall cladding flashing and trim?

Wall cladding refers to a variety of decorative coverings, typically used on the exterior on buildings. Similar to siding , the seams where the cladding meets the rest of the house need to be securely sealed (caulked) so that moisture doesn’t enter the walls .

How do you seal roof flashing?

Renew flashing seals by chipping out the old mortar and caulking along the edges of the flashing . Use special masonry caulk to seal the joints between the flashing and the chimney. Seal the seam between the cap and step flashing with urethane roofing cement or silicone caulking compound, as shown at right.

You might be interested:  Masonry waterproofing products

What is a flashing detail?

Flashing refers to thin pieces of impervious material installed to prevent the passage of water into a structure from a joint or as part of a weather resistant barrier system.

What types of movement joints are required in a concrete masonry wall?

Masonry movement joints may be described as one of three types: expansion joints, contraction or control joints, and isolation joints . Expansion joints (EJs) are used to accommodate volume expansion of clay masonry.

Why is it wise to spend a little extra to use time tested and proven materials for flashings in masonry walls?

Why is it wise to spend a little extra to use proven materials for flashings in masonry walls ? the additional cost is very small as a percentage of overall construction cost, and the potential cost of replacing defective or deteriorated flashings in a masonry wall is extremely high.

How might you prevent or control cracking in a masonry wall?

Tip: Use expansion joints to separate adjacent brick walls of different heights to avoid cracking caused by differential movement. The joint can be placed at the interior corner or, if appropriate, a foot or so away from the corner to provide a masonry bonded corner for stability.

How do you install flashing under existing siding?

How do you install flashing under existing siding ? Slice along the bend line about 4 inches into the first piece of flashing at the bottom of the roof with tin snips.. Lay a shingle over the step flashing starting at the roof edge. Cut a piece of flashing along the bend line about half the length of the strip to flash the peak of the roof.